Some questions for the experts: - I have a 840 display installed, it shares the bus with the programmer cable. But it does not seem to work sometimes the output of 'RPM x' info will stop for a moment but will resume activity soon. I did also read about entering commands in the terminal, using ':'. Using an oscilloscope I have checked some bits are sent in the TX wire, but still conection is not established.
I even tried with an old win98 PC, but the programming software still refuses to connect (terminal work though). I have tried 4 differente USB/Serial adapters, some will show the terminal output correctly, others will not. But the programmer software still refuses to connect. The controller seems to work, it will accelerate the motor (the encoder settings are probably wrong, but it works anyway). There is a new town on the northern coast of Spain (Bilbao) and the connection to Valladolid. Version 4.5.5a / Bugfix online - With this version, the reported bugs have been fixed, added a few sites and the Hermes villages Cross. Again, I can see all that using putty, dacio, etc. &0183 &32 Euro Truck Simulator 2 Mody Mapy Polski Chomikuj. Controller but I doubt it is curtis, then that is not compatible with the software / cable you have.Ĭommunication error with controller' After assembling all the parts requested by the controller, the controller stopped printing error codes and printed run info like RPM, Amps, etc.I can change that info with the 'menu mode' switch.
1314-4401 PC PROGRAMMING STATION - i read and save the *.par. Instead, the 1314 v 3.21 is available for download here. This Dealer Level Curtis Model 1314 PC Programming Station provides a Windows. Curtis software 1314, however, refused connection: 'Error 0023 Initialization of communication interface failed.Ĭurtis 1314 PC-Based Programming Kit. I tried connecting to it without motor, throttle.Terminal software (putty & dacio) showed error codes (scode x) signaling the parts that were missing, like the motor. I don't know much about it's previous settings or use conditions. As I didn't find anything I am opening this thread (well, I found lots of hints about connection problems and tried many of them, but it seems my problem is somewhat different). Hello I have been reading the forum up and down looking for any clue about my connection problem.